Cleaning and Lubricating Handpieces
It is a good practice to lubricate handpieces twice daily, after morning sessions and at the end of a day. Further, in case that you use a handpiece continuously over half an hour, lubrication during treatment is highly recommendable. Use a mist absorbing pack to avoid air-borne oil mist.
Care3Plus
NSK recommends using Care3 Plus for automated cleaning and lubrication of handpieces. It’s simple to use and offers consistent lubrication effects regardless of operator’s skill and experience.

Simple operation


Open the door and properly connect handpieces to the couplings. (Up to 3 handpieces at one time)
Closed the door completely. Care3 Plus will not start if the door is closed incompletely.
Select a cycle (Short, Long or Extra Long) for each handpiece respectively.
Press the START button. Wait for about two minutes till Care3 Plus completes cleaning and lubrication.
pagetop